Setting Items - Mitsubishi Electric QJ71LP21 Reference Manual

2 SYSTEM CONFIGURATION

2.2.2 Setting items

2 - 5
(1) Table 2.3 lists the parameter setting items of the multiplexed remote master
station (DM ) and multiplexed remote sub-master station (DSM
R
Table 2.3 Setting Items of Multiplexed Remote Master Station and
Multiplexed Remote Sub-Master Station
Setting item
Network module switch
STATION NO.
MODE
Parameter setting on GX Developer
MELSECNET/H Ethernet module count setting
Network type
Starting I/O
Network No.
Total stations
Group No.
Mode
Common parameters
Auxiliary setting
Station specific parameters
Refresh parameters
Valid module during other
station access
Interlink transmission parameter
Routing parameters
: Always set,
POINT
1: Set Total stations and common parameters of the multiplexed remote sub-
master station when using the multiplexed remote sub-master station to
resume the network. The settings must be the same as those of the
multiplexed remote master station.
For example, if the multiplexed remote master station is powered off and then
on during network control by the multiplexed remote sub-master station, the
multiplexed remote sub-master station resumes networking as a master
operating station.
2 : Refer to the "Q Corresponding MELSECNET/H Network System Reference
Manual (PLC to PLC Network) (SH-080049)".
Multiplexed remote
Multiplexed remote
sub-master station
master station (DM )
R
0
MELSECNET/H MELSECNET/H
(Multiplexed remote (Multiplexed remote
master station) sub-master station)
: Default setting, : Set as needed,
MELSEC-Q
).
R
Reference
(DSM )
R
1 to 64 Section 4.2.1
Section 4.2.1
Section 5.1.1
Section 5.1.2
Section 5.1.2
1
Section 5.1.2
Section 5.1.2
Section 5.1.2
1
Section 5.1.3
Section 5.1.4
—
Section 5.1.5
Section 5.1.6
—
: No need to set
2
2 - 5