Available Device Ranges - Mitsubishi Electric QJ71LP21 Reference Manual

2 SYSTEM CONFIGURATION

2.1.3 Available device ranges

2 - 3
(2) Table 2.2 shows the setting items on the remote I/O module of the remote I/O
station (R) and the parameter setting items on the GX Developer.
Table 2.2 Remote I/O station setting items
Setting items
Network module switch
STATION NO.
MODE
Parameter setting on GX Developer
PLC system setting
PLC RAS setting
I/O assignment
Operation setting
Ethernet setting
CC-Link setting
Remote password setting
GX Configurator setting
Initial setting
Auto refresh setting
: Always set,
2 : Refer to "QCPU User's Manual (Functional Explanation: Program Fundamentals)
(SH-080484ENG)".
3 : Refer to "Q Corresponding Ethernet Interface Module User's Manual (Basic) (SH-
080009)". Note that interrupt setting is not available.
4 : Refer to "CC-Link System Master/Local Module User's Manual (SH-080394E)".
Note that interrupt setting is not available.
5 : Refer to the user's manual of the corresponding intelligent function module.
The remote I/O network can use the following device ranges within each network
module.
These device ranges indicate the remote master station.
Device Range setting
LB 0 to 3FFF (16384 points)
H
H
LW 0 to 3FFF (16384 points)
H
H
LX 0 to 1FFF (8192 points)
H
H
LY 0 to 1FFF (8192 points)
H
H
0
CPU module B/W
Network module LB/LW
CPU module X/Y
Network module LX/LY
: Default setting,
The device range (excluding that of I/O module mounted on the host
station) should be assigned to each network module.
1000
H
(4096)
Actual I/O
Actual I/O
1: Expandable by changing from [PLC parameters] - [Device settings]
MELSEC-Q
Remote I/O station (R)
1 to 64
: Set as needed,
Other
—
2000 3000
H H
(8192) (12288)
Extended
: Available device range
Reference
Section 4.2.2
Section 4.2.2
2
2
2
Section 5.2.1
3
4
Section 7.12
5
5
: No need to set
3FFF
H
(16383)
1
2 - 3