Mitsubishi Electric QJ71LP21 Reference Manual page 119

5 PARAMETER SETTINGS
(2) Parameter settings for remote I/O station
Not required
required
1) If no parameters are written to the remote I/O station, operation is performed
2) If the CPU module for the remote master station is reset or if set from STOP to
3) Even if only one of the following settings is corrected, all the parameters are
5 - 2
functions as necessary.
PLC Parameters
(1) PLC system settings
(2) PLC RAS settings
(3) Operational settings
(4) I/O assignment
Intelligent function module parameter settings
functions as necessary.
Not
Network parameter settings
(1) Ethernet
(2) CC-Link
Writing parameters to remote I/O module
Resetting network module
To cable connection
POINT
using the default settings. (See Section 5.2.1)
RUN, it also resets the remote I/O station.
However, the remote I/O station can be reset when the following conditions are
satisfied:
• When the PLC parameter/network parameter or remote password of a
remote I/O station is corrected and the corrected parameter is not effective
because the remote I/O station has been reset or due to other reasons.
• When a stop error has occurred. (Refer to section 8.3.2.)
written to the remote I/O module: PLC parameters, intelligent function module
parameters, network parameters, and remote password
1: The following settings can be performed for the I/O assignment.
1) Input module for I/O response time.
2) Output module error time output mode.
3) I/O assignment
4) Setting switches for intelligent function module.
2: Refer to the intelligent function module user's manual for details about
intelligent function module parameters.
Set the following 1
Required
1
2
Set the following
Required
MELSEC-Q
· · · · Section 5.1.1
· · · ·
Section 5.2.1
· · · ·
Section 4.6
5 - 2
5