High/Low Beam Switch; Flash-To-Pass; Automatic Headlights - If Equipped - Jeep Wrangler2018 Owner's Manual

Hide thumbs Also See for Wrangler2018:

Table of Contents

64 GETTING TO KNOW YOUR VEHICLE

High/Low Beam Switch

Push the multifunction lever toward the instrument panel

to switch the headlights to high beams. Pull the multifunc-

tion lever back toward the steering wheel to return the

lights to low beams.

Multifunction Lever

You can signal another vehicle with your headlights by

lightly pulling the multifunction lever toward you. This

will cause the high beam headlights to turn on, and remain

on, until the lever is released.

Automatic Headlights — If Equipped

This system automatically turns the headlights on or off

according to ambient light levels. To turn the system on,

rotate the headlight switch clockwise to the last detent for

automatic headlight operation. When the system is on, the

headlight time delay feature is also on. This means the

headlights will stay on for up to 90 seconds after you place

the ignition into the OFF position. To turn the automatic

system off, move the headlight switch out of the AUTO

NOTE: The engine must be running before the headlights

will come on in the automatic mode.

Table of Contents