Jeep Wrangler2018 Owner's Manual page 299

If the vehicle is not in PARK and the driver turns off the
engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions are met:
• Vehicle is equipped with an 8-speed transmission
• Drivers door is ajar or in conditions where driver door is
removed an additional trigger would be if the driver is
off the seat (seat pad sensor detects driver missing).
• Vehicle is not in PARK
• Vehicle Speed is 0 mph (0 km/h)
• Ignition switched from RUN to OFF
NOTE: For Keyless Go equipped vehicles, The engine will
turn off and the ignition switch will change to ACC mode.
After 30 minutes the ignition switches to OFF automati-
cally, unless the driver turns the ignition switch OFF.
If the vehicle is not in PARK and the driver exits the vehicle
with the engine running, the vehicle may AutoPark.
AutoPark will engage when all of these conditions are met:
• Vehicle is equipped with an 8-speed transmission
• Drivers door is ajar or in conditions where driver door is
removed an aditional trigger would be if the driver is off
the seat (seat pad sensor detects driver missing).
• Vehicle is not in PARK
• Driver's door is removed
• Vehicle speed is 1.2 MPH (2.0 km/h) or less
• Driver's seat belt is unbuckled
• Driver's door is ajar
• Brake Pedal is not depressed
The MESSAGE " AutoPark Engaged Shift to P then Shift
to Gear" will display in the instrument cluster.
NOTE: In some cases the ParkSense graphic will be
displayed in the instrument cluster. In these cases, the
shifter must be returned to "P" to select desired gear.
If the driver shifts into PARK while moving, the vehicle
may AutoPark.
AutoPark will engage ONLY when vehicle speed is 1.2 MPH
(2.0 km/h) or less.
The MESSAGE " Vehicle Speed is Too High to Shift to P"
will be displayed in the instrument cluster if vehicle speed
is above 1.2 MPH (2.0 km/h).
STARTING AND OPERATING 297
6