Jeep Wrangler2018 Owner's Manual page 196

194 GETTING TO KNOW YOUR INSTRUMENT PANEL
— Service 4WD Warning Light — If Equipped
If the light stays on or comes on during driving, it means
that the 4WD system is not functioning properly and that
service is required. We recommend you drive to the nearest
service center and have the vehicle serviced immediately.
— Service Stop/Start System Warning Light —
If Equipped
This telltale will turn on to indicate the Stop/Start system
is not functioning properly and service is required. Contact
your authorized dealer for service.
— Speed Control Fault Warning Light
This telltale will illuminate to indicate the Speed Control
System is not functioning properly and service is required.
Contact your authorized dealer.
— Sway Bar Fault Warning Light
This light will illuminate when there is a fault in the sway
bar disconnect system.
— Tire Pressure Monitoring System (TPMS)
Warning Light
The warning light switches on and a message is displayed
to indicate that the tire pressure is lower than the recom-
mended value and/or that slow pressure loss is occurring.
In these cases, optimal tire duration and fuel consumption
may not be guaranteed.
Should one or more tires be in the condition mentioned
above, the display will show the indications corresponding
to each tire in sequence.
CAUTION!
Do not continue driving with one or more flat tires as
handling may be compromised. Stop the vehicle,
avoiding sharp braking and steering. If a tire puncture
occurs, repair immediately using the dedicated tire
repair kit and contact your authorized dealer as soon as
possible.