Daytime Running Lights (Drls); If Equipped; High/Low Beam Switch; Flash-To-Pass - Jeep Wrangler Owner's Manual

D R L
AYTIME UNNING IGHTS
I E
F QUIPPED
The Daytime Running Lights are in a dedicated position
below the headlight assembly. DRLs are active when the
Low Beams are not on, and the engine is running. DRLs
may be deactivated by applying the parking brake.
NOTE:
On some vehicles, the Daytime Running Lights may deac-
tivate or reduce intensity on one side of the vehicle (when
a turn signal is activated on that side), or on both sides of
the vehicle (when the hazard warning lights are activated).
H /L B S
IGH OW EAM WITCH
Push the multifunction lever toward the instrument panel
to switch the headlights to high beams. The lever will
return to the centered position. To return the headlights to
low beam, pull the lever toward the steering wheel, or
push the lever toward the instrument panel.
(DRL ) —
S
F -T -P
LASH O
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This will
cause the high beam headlights to turn on, and remain on,
until the lever is released.
A
UTOMATIC
This system automatically turns the headlights on or off
according to ambient light levels. To turn the system on,
rotate the headlight switch clockwise to the last detent for
automatic headlight operation. When the system is on, the
headlight time delay feature is also on. This means the
headlights will stay on for up to 90 seconds after you place
the ignition into the OFF position. To turn the automatic
system off, move the headlight switch out of the AUTO
position.
Multifunction Lever
ASS
H — I E
EADLIGHTS F QUIPPED
GETTING TO KNOW YOUR VEHICLE
NOTE:
 Headlight time delay must first be enabled with the
Uconnect system page 128.
Ú
 The engine must be running before the headlights will
come on in the automatic mode.
H T D
EADLIGHT IME ELAY
This feature provides the safety of headlight illumination
for up to 90 seconds when leaving your vehicle in an unlit
area. The time delay of the headlights is programmable
between 0, 30, 60 and 90 seconds within Uconnect
Settings page 128.
Ú
To activate the delay feature, place the ignition in the OFF
position while the headlights are still on. The delay interval
begins when the headlight switch is turned off from the
low beam position. If the headlight switch is in AUTO and
the headlights were on before the ignition was turned off,
the delay interval begins automatically.
The feature is disabled by turning on the headlights or
parking lights, or by moving the ignition switch out of the
OFF position. If you shut off the lights before the ignition is
turned on, they will turn off in the normal manner.
NOTE:
The lights must be turned off within 45 seconds of placing
the ignition in the OFF position to activate this feature. If
the headlight switch is in the AUTO position prior to placing
43