Jeep Wrangler2018 Owner's Manual page 91

4. Install the rear retainers on each side of the rear of the
vehicle using the provided #50 Torx head driver and
ratchet. Refer to the table below for recommended
torque specifications.
Installing Rear Retainers
Torque Maximum
Specification
For Torx Screw
119.5 In-lbs 150.5 In-lbs
13.5 N·m 17.0 N·m
5. Making sure the lift assist mechanism is in the "lock"
position, lift the soft top into the rear of the vehicle with
the side links pointing toward the front. Lower the lift
assist mechanisms onto its retainers on both sides (on
the inside of the sport bar).
Minimum
NOTE: If you are doing this alone, use one arm to hold the
soft top up, the other to align the brackets.
106.2 In-lbs
12.0 N·m
GETTING TO KNOW YOUR VEHICLE 89
Soft Top In Place
3