Transfer Case; Manual Transmission - Jeep Wrangler2018 Owner's Manual

448 SERVICING AND MAINTENANCE
Fluid Level Check
Lubricant should be approximately 1/8 inch (3 mm) below
the bottom edge of the oil fill hole.
NOTE: Make sure that the vehicle is level and supported
by the axles
Adding Fluid
Add lubricant only at the fill hole and only to the level
specified above.
Selection Of Lubricant
Use only the manufacturer's recommended fluid. Refer to
"Fluids And Lubricants" in "Technical Specifications" for
further information.

Transfer Case

Selection Of Lubricant
Use only the manufacturer's recommended fluid. Refer to
"Fluids And Lubricants" in "Technical Specifications" for
further information.
Fluid Level Check
This fluid level can be checked by removing the filler plug.
The fluid level should be to the bottom edge of the filler
plug hole with the vehicle in a level position.
Drain And Refill
Refer to the "Maintenance Plan" in this section for the
proper maintenance intervals.

Manual Transmission

Selection Of Lubricant
Use only manufacturer's recommended manual transmis-
sion fluid. Refer to "Fluids And Lubricants" in "Technical
Specifications" for further information.
Fluid Level Check
Check the fluid level by removing the fill plug. The fluid
level should be between the bottom of the fill hole and a
point not more than 3/16 of an inch (4.76 mm) below the
bottom of the hole.
Add fluid, if necessary, to maintain the proper level.