Jeep Wrangler2018 Owner's Manual page 80

78 GETTING TO KNOW YOUR VEHICLE
Icon
Faceplate Knob Blower Control
Blower Control is used to regulate the amount of air forced through the climate system. There
are seven blower speeds available. The speeds can be selected using either the blower control
knob on the faceplate or the buttons on the touchscreen.
• Faceplate: The blower speed increases as you turn the blower control knob clockwise from
Touchscreen
Buttons
• Touchscreen: Use the small blower icon to reduce the blower setting and the large blower
Modes Control
Press the button to adjust airflow distribution. The airflow distribution mode can be adjusted so
air comes from the instrument panel outlets, floor outlets, defrost outlets and demist outlets.
Panel Mode Panel Mode
Air comes from the outlets in the instrument panel. Each of these outlets can be individually
adjusted to direct the flow of air. The air vanes of the center outlets and outboard outlets can be
moved up and down or side to side to regulate airflow direction. There is a shut off wheel lo-
cated below the air vanes to shut off or adjust the amount of airflow from these outlets.
the lowest blower setting. The blower speed decreases as you turn the blower control knob
counterclockwise.
icon to increase the blower setting. The blower can also be selected by pressing the blower
bar area between the icons.
Description