Jeep Wrangler2018 Owner's Manual page 363

Bumper End Cap Removal
The end caps on your vehicle's front bumper can be
removed by following the steps below:
1. Loosen the two bolts that retain the GAWR bracket
(Bolts #1 and #2) to the end cap using a T45 torx bit
screw driver. Do not remove the bolts.
Bolt #1
Bolt #2
2. Remove the remaining 8 bolts. The end cap can now be
expanded open.
3. Gently remove the end cap from the vehicle and store it
where it will not get damaged.
4. Repeat this procedure on the other side.
STARTING AND OPERATING 361
6