Configuring The Console Idle Privileged Exec Timeout - Cisco ASR 1001-X Hardware Installation Manual

Cisco ASR 1001-X Router Power Up and Initial Configuration
Command or Action
Step 4
end
Example:
Router(config)# end
Step 5 enable
Example:
Router> enable
Step 6
end
Example:
Router(config)# end

Configuring the Console Idle Privileged EXEC Timeout

This section describes how to configure the console line's idle privileged EXEC timeout. By default, the
privileged EXEC command interpreter waits 10 minutes to detect user input before timing out.
When you configure the console line, you can also set communication parameters, specify autobaud connections,
and configure terminal operating parameters for the terminal that you are using. For more information on
configuring the console line, see the
Configuration Guide
"Troubleshooting and Fault Management" chapters.
SUMMARY STEPS
1. enable
2. configure terminal
3. line console 0
4. exec-timeout minutes [seconds]
5. end
6. show running-config
DETAILED STEPS
Command or Action
Step 1 enable
Purpose
Returns to privileged EXEC mode.
Enables privileged EXEC mode.
Verify that your new enable or enable secret password works.
(Optional) Returns to privileged EXEC mode.
Cisco IOS Configuration Fundamentals and Network Management
. In particular, see the "Configuring Operating Characteristics for Terminals" and
Purpose
Enables privileged EXEC mode.
Using the Cisco IOS-XE CLI--Manual Configuration
Cisco ASR 1001-X Router Hardware Installation Guide
57