Configuring The Console Idle Privileged Exec Timeout - Cisco ASR 1001-X Installation Manual

Performing the Initial Configuration on the Router
Command or Action
Step 5
enable
Example:
Router> enable
Step 6
end
Example:
Router(config)# end

Configuring the Console Idle Privileged EXEC Timeout

This section describes how to configure the console line's idle privileged EXEC timeout. By default, the
privileged EXEC command interpreter waits 10 minutes to detect user input before timing out.
When you configure the console line, you can also set communication parameters, specify autobaud
connections, and configure terminal operating parameters for the terminal that you are using. For more
information on configuring the console line, see the
Network Management Configuration
Characteristics for Terminals" and "Troubleshooting and Fault Management" chapters.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
line console 0
Example:
Router(config)# line console 0
Cisco ASR 1001-X Router Hardware Installation Guide
5-10
enable
configure terminal
line console 0
exec-timeout minutes [seconds]
end
show running-config
Chapter 5 Cisco ASR 1001-X Router Power Up and Initial Configuration
Purpose
Enables privileged EXEC mode.
Verify that your new enable or enable secret password
works.
(Optional) Returns to privileged EXEC mode.
Cisco IOS Configuration Fundamentals and
Guide. In particular, see the "Configuring Operating
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Enters global configuration mode.
Configures the console line and starts the line configuration
command collection mode.
OL-32376-02