Device Overview; Connectors - Omicron Lab Bode 100 User Manual

5

Device overview

Bode 100 is a USB controlled vector network analyzer. The system consists of the Bode 100 hardware
and the Bode Analyzer Suite software. In the following the Bode 100 hardware is described in detail.
To learn more about the Bode Analyzer Suite, please check out
5.1

Connectors

CAUTION
To ensure save operation and to prevent injuries it is recommended to connect
Bode 100 to ground using the ground connector at the rear panel at all times.
NOTICE
To avoid damage of Bode 100 make sure that the absolute maximum ratings defined in chapter
4.1 Absolute maximum ratings
For save operation it is strongly recommended only to use the power supply delivered with
Bode 100.
Bode 100 provides the following three connectors at the front panel:
• OUTPUT: signal output (BNC socket)
• CH 1: channel 1 signal input (BNC socket)
• CH 2: channel 2 signal input (BNC socket)
Figure 5-1: Bode 100 front view
14
on page 10 are not exceeded at any time.
6.1 Start screen on page 18 ff.
OMICRON Lab