Trace Configuration - Omicron Lab Bode 100 User Manual

6.2.2 Trace configuration

In a Frequency Sweep measurement, the right hand side of the Bode Analyzer Suite shows the Trace
configuration. The Trace configuration allows to choose what measurement (Gain, Impedance,
Reflection, Admittance) is performed and how it is displayed in the chart.
Trace configuration box:
Memory configuration box:
Hint: By clicking the inner border of the Measurement configuration or Trace configuration
you can collapse these configuration areas to create a bigger chart area. You can fold out
the configurations anytime by clicking the respective areas at the side of the chart area. For
more details refer to the figure below.
OMICRON Lab
Bode Analyzer Suite introduction
The Trace configuration box displays the trace-name
and contains the following trace-display settings:
Measurement: Impedance, defines that Trace 1
measures impedance.
Display: Measurement, indicates that the chart shows
the measured trace.
Note that memory curves are displayed as well.
Format: Magnitude, defines that Trace 1 displays the
Magnitude of Impedance.
Ymax: 100 Ω, The upper limit of the y-axis displayed in
the diagram.
Ymin: 1 mΩ, The lower limit of the y-axis displayed in
the diagram.
Y-axis scale : Log(Y), Currently the y-axis is set to a
logarithmic scaling.
Learn more about the trace configuration box in
9.6 Using the trace configuration
The memory configuration box allows to control the
memory curves:
Click to copy the current measurement data to
Memory 1.
Click to delete the Memory 1 trace.
Click to link the cursors to Memory 1.
Furthermore it can be selected with which trace (in
which diagram) the memory is shown.
Learn more about the memory curves in
memory traces on page 111.
on page 114.
9.5 Using the
23