Hardware Setup - Omicron Lab Bode 100 User Manual

6.5

Hardware setup

By clicking on the Hardware setup icon
The hardware setup dialog shows the internal connections of Bode 100 as well as the external
connection to the DUT. Depending on the selected measurement mode, hardware settings such as
Channel termination, Receiver connection or an external Probe factor can be changed by clicking on
the icons shown in the Hardware setup dialog.
Figure 6-5: Hardware setup dialog in Gain/Phase measurement mode.
Depending on the measurement mode, some of the following settings can be changed by the user:
• Source mode: Choose between Auto off or Always on. More details on the source behavior of
Bode 100 can be found in
• Source level: Set the constant source level or the reference level when the shaped level function
is used.
• Receiver bandwidth: Select the receiver bandwidth used for the measurement.
32
, the hardware setup dialog is opened.
9.2 Signal source settings on page 98.
OMICRON Lab