Faults / Troubleshooting - Siemens FC7xx Operation Manual

Faults / Troubleshooting

10
10 Faults / Troubleshooting
'Fault'
Automatic detector
Manual call point
Mains failure
Paper out
174 | 184
Building Technologies
Fire Safety
If the ↑ site displays 'Fault', you will find in the table below a list with possible
'Faults' including information on possible causes.
If a 'Fault' cannot be rectified with the help of these operation instructions, please
contact the service engineer.
Cause Remedy
Detector is missing Re-insert detector
Detector is out of Replace the detector.
order
NOTICE! Any defective detector must always be replaced
by another detector of the same type.
Glass pane broken Replace glass pane
Other damages Contact service provider
No action required.
Mains failure in the
public network
Emergency power supply is ensured by batteries during at
minimum 12 hours; depending on the customer
specification up to 72 hours.
Fuse damaged Check fuses (current distributor of the building) and replace
them if necessary.
Paper roll in the Insert printing paper
printer has been
used up
With all other 'Faults', the service provider in account must be contacted.
See also
1 Insert printing paper [➙ 107]
A6V10211076_i_en_--
2015-12-15