System Functions; Note On The Configuration Of The Local Fire Detection Installation - Siemens FC7xx Operation Manual

6 System functions

6.1 Note on the configuration of the local fire detection
Parameters
Operation level access
Remote transmission of 'ALARMS'
Alarm sequence taking into account the staff present on site
Switching from 'Manned operation' to 'Unmanned operation'
Automatic switching time from 'Manned operation' to 'Unmanned
operation'
Automatic switching time from 'Manned operation' to 'Unmanned
operation'
Delay t1
Delay t2
Switchover
Summer time / Winter time
Remote transmission of 'Faults'
Function Evacuate
Access to acknowledgement
'Faults' must be reset
'Faults' are generally immediately transmitted to the receiving centre
Manual call points in mixed detector zones always trigger an
'ALARM', even when the detector zone is switched off
Maximum operation time without mains supply
Building plan handed over
Building Technologies
Fire Safety

Note on the configuration of the local fire detection installation

See also
1 Event categories [➙ 168]
installation
Each fire detection system is individually configured. The configuration has an
impact on the operation. You can see the configuration of your fire detection
installation in the following table.
System functions
Configuration
O via password
O via key switch
O yes
O no
O yes
O no
O automatic
O manual
O indicated
O not indicated
O not activated
____ minutes
____ minutes
O automatic
O manual
O yes
O no
O activated
O not activated
O always possible
O via password / key switch
O yes
O no
O yes
O no
O yes
O no
____ hours
on _________
by _________
A6V10211076_i_en_--
6
111 | 184
2015-12-15