Table of Contents
Advertisement
USB port, user will be asked to provide valid keyword when connecting FMA120 to configurator.
User is given 5 attempts to enter keyword. After entering valid keyword, counter resets to 5.
port, after reconnecting using 'Connect' button, configurator does not ask for keyword.
5.7
It will send data later when GPRS is available again. Note that FMA120 can have memory full of
records. In such case it will start deleting oldest records in order to save new ones. Sending all
the data records to server may take some time. Sending 3500 records for FMA120 may take for
about 2 hours (exact time may differ depending on GPRS/server load).
manual" documentation.
5.8
Downloaded from
www.Manualslib.com
Keyword is 4 – 10 symbol length. If keyword is set, every time user reconnects FMA120 to
If user disconnects FMA120 using 'Disconnect' button and does not disconnect from USB
ATTENTION! If you have entered a keyword, disconnected from the
configurator and then later connected again, you will need to enter the
keyword that you have entered previously. If you have forgotten it, please
contact your local sales manager.
Record storage
FMA120 can store up to 3500 data records if GSM or GPRS is not available at the moment.
You can access all uploaded data from TAVL4 application.
More details on how to use TAVL application please refer to "TAVL4 application user
System settings
System settings have 7 configurable parameters:
• Deep sleep settings, where user can turn deep sleep on or off
• Analog Input Settings, where user can choose analog input range 10 V or 30 V,
depending on needed accuracy (lower range gives higher accuracy of
measurements), and input voltage;
• Object Motion Detection Settings, where user can configure 3 ways how FMA120
will detect stopped movement, and change its working mode (for working modes,
read section 5.13);
• Static navigation settings, where user can turn static navigation on or off;
• Records Settings, where user can enable or disable records when GPS is not
available (no time synchronization);
• GNSS Settings, where user can choose satellite system and time synchronization via
NTP (Network Time Protocol)
• Ignition Source sets ignition triggered functionalities to be triggered by:
o Power Voltage (if voltage is between High Voltage Level and Low Voltage
Level the ignition is considered to be turned on);
o Digital Input (DIN1 ON – ignition on, DIN1 OFF – ignition off);
o Movement (if accelerometer/movement sensor detects movement then
ignition is on, if movement stops – ignitin is off).
manuals search engine
29
Advertisement
Table of Contents
