Parameter List; Global Parameters; Record Search (Id=105); Link Timeout (Id=107) - Teltonika FM3200 User Manual

9

Parameter List

FM3200 uses only one profile, therefore all changes to parameters must be done in profile1
(profile0 is for global parameters).
9.1

Global Parameters

Record search (ID=105)

Record search parameter is responsible for record searching order. Value of 0 arranging data
starting from newest, while value of 1 arranging data starting from oldest.
Minimum Maximum
value value
0 1

Link timeout (ID=107)

Link timeout in seconds, indicates link timeout after last record sending. Disconnection from
server is not immediate after data packet is sent. Module disconnect from server after indicated
timeout.
Minimum Maximum
value value
5 259200
9.2

Data acquisition and sending parameters

Time based acquire interval (ID=11)

Time interval in seconds, indicating condition to acquire new record. 0 – disabled.
Minimum Maximum
value value
0 9999999

Distance based acquire interval (ID=12)

Distance in meters, indicating condition to acquire new record. Record is stored when the
distance between previous record is greater than parameter's value. 0 – disabled
Minimum Maximum
value value
0 65535

Angle based coordinate acquisition (ID=13)

Angle in degrees, indicating condition to acquire new record. If angle difference between last
recorded coordinate and current position is greater than defined value, new record is stored. This
parameter is operational, when speed is higher then 10km/h. 0 – disabled
Recommended
Goes with (depends on) parameters
value
- Data Send interval (ID=270)
Recommended
Goes with (depends on) parameters
value
- Data Send interval (ID=270)
Recommended
Goes with (depends on) parameters
value
Distance based acquire interval
5
Angle based coordinate acquisition
Recommended
Goes with (depends on) parameters
value
Time based acquire interval (ID=11)
50 Angle based coordinate acquisition
(ID=12)
(ID=13)
(ID=13)
Value type
S8
Value type
U32
Value type
U32
Value type
U16
35