Usb Power Selection; Internal Peripheral Device Connections; Sata Drive Connection; Table 4-6: Bios Options And Configured Usb Ports - IEI Technology IMBA-Q170-i2 User Manual

4.11.7 USB Power Selection

The USB power selection is made through the BIOS menu in "Chipset
Configuration". Use the USB Power SW1 and the USB Power SW2 BIOS options to
configure the correspondent USB ports (see Table 4-6) and refer to Table 4-7 to select
the USB power source.
BIOS Options
USB Power SW1
USB Power SW2

Table 4-6: BIOS Options and Configured USB Ports

Options
+5V DUAL
+5V

Table 4-7: USB Power Source Setup

Please refer to Section 5.4.2 for BIOS setup.

4.12 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the onboard connectors.

4.12.1 SATA Drive Connection

The IMBA-Q170-i2 is shipped with two SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector until it clips into place. See Figure 4-21.
Page 80
IMBA-Q170-i2 ATX Motherboard
Configured USB Ports
K/M_USB1 (external USB 2.0 ports)
LAN1_USB1 (external USB 3.0 ports)
LAN2_USB2 (external USB 3.0 ports)
USB1 (internal USB 2.0 ports)
USB2 (internal USB 2.0 ports)
USB3-1 (internal USB 3.0 ports)
Description
+5V dual (default)
+5V
PCH-IO