Table of Contents
Advertisement
4.5 DIMM Installation
To install a DIMM, please follow the steps below and refer to Figure 4-6.
Figure 4-6: DIMM Installation
Step 1:
Open the DIMM socket handles. Open the two handles outwards as far as
they can. See Figure 4-6.
Step 2:
Align the DIMM with the socket. Align the DIMM so the notch on the memory
lines up with the notch on the memory socket. See Figure 4-6.
Step 3:
Insert the DIMM. Once aligned, press down until the DIMM is properly seated.
Clip the two handles into place. See Figure 4-6.
Step 4:
Removing a DIMM. To remove a DIMM, push both handles outward. The
memory module is ejected by a mechanism in the
Page 66
IMBA-Q170-i2 ATX Motherboard
socket.Step 0:
Advertisement
Table of Contents
