Table of Contents
Advertisement
Step 5:
Removing the iRIS-2400 module. To remove the iRIS-2400 module, push both
handles outward. The module is ejected by a mechanism in the
NOTE:
After installing the iRIS-2400 module, use LAN2_USB2 port to
establish a network connection. Please refer to Section 4.15 for IPMI
setup procedures.
4.7 Full-size PCIe Mini Card Installation
The PCIe Mini card slot allows installation of either a full-size or half-size PCIe Mini card.
To install a full-size PCIe Mini card, please follow the steps below.
Step 1:
Locate the PCIe Mini card slot. See Chapter 3.
Step 2:
Remove the retention screw. Remove the retention screw as shown in
Figure 4-8.
Figure 4-8: Removing the Retention Screw
Page 68
IMBA-Q170-i2 ATX Motherboard
socket.Step 0:
Advertisement
Table of Contents
