Table of Contents
Advertisement
IMBA-Q170-i2 ATX Motherboard
4.6 iRIS Module Installation
WARNING:
The iRIS module slot is designed to install the iRIS-2400 module only.
DO NOT install other modules into the iRIS module slot. Doing so may
cause damage to the IMBA-Q170-i2.
To install the iRIS-2400 module, please follow the steps below and refer to Figure 4-7.
Figure 4-7: iRIS Module Installation
Step 1:
Locate the iRIS module slot. See Figure 3-16.
Step 2:
Open the socket handles. Open the two handles outwards as far as they can.
See Figure 4-7.
Step 3:
Align the iRIS-2400 module with the socket. Align the iRIS-2400 module so
the notch on the module lines up with the notch on the socket. See Figure 4-7.
Step 4:
Insert the iRIS-2400 module. Once aligned, press down until the iRIS-2400
module is properly seated. Clip the two handles into place. See Figure 4-7.
Page 67
Advertisement
Table of Contents
