Usb Mode - sauter SW 1000 Instruction Manual

device can be integrated with another system, especially if there is a risk of
power outage. In case of operating voltage loss, the sound level meter will
automatically restart.
Boot & Auto Meas.:
In this case, the hardware mode switch should be set to Boot. Once this mode is
selected, not only the sound level meter will boot upon the supply of operating
voltage, but the device will also start measuring. After integrating the sound level
meter with another system, upon a loss of operating voltage the device will boot
and start the measurement.
Hardware Mode Switch:
The hardware mode switch is located in the battery container. It can easily be
accessed after removing the batteries. The switch should be moved with pliers or
a pencil to the "Boot" or "Normal" position.
☆ Hint: This area is sensitive to electrostatic loads. Eliminate any electro-
static loads before handling.

4.4.10 USB Mode

Always Ask:
When you connect the device to a computer using a USB cable, you will always
be asked about the mode. You should choose an option in due time, otherwise
the computer will not be able to detect the sound level meter due to the excess
of time.
USB Disk Mode:
The device always operates in the USB Disk Mode, so the question will not be
shown when connecting it to a computer using a USB cable. The sound level
meter can be detected by the computer as an exchangeable USB drive without
the need to install a driver. You can directly access the files stored in the mi-
croSD card using Windows Explorer.
34
In the USB Mode menu, you can set the operating mode of the
sound level meter connected to a computer using a USB cable.
The following options are available: Always Ask, USB Disk Mode
and Modem Mode.
SW-BA-e-1710