Trigger; Date & Time - sauter SW 1000 Instruction Manual

4.4.4 Trigger

The measurement starts after connecting a signal cable to ground and stops upon
disconnection. Note that when the Trigger function is active, the <START/STOP>
key is unavailable.
4.4.5 Date & Time
<ENTER> to save the setting.
level meter is incorrect due to a low voltage of the RTC battery. Advice on the
change of RTC battery: To remove the cover, unscrew the 5 bolts located at the rear
of the sound level meter. The RTC battery is located on the plate, as shown in the
figure. The battery has the form of a CR-1220 button cell.
30
The Trigger menu allows you to activate or deactivate the trigger
function. Trigger is the analogue input which, using remote con-
trol commands, enables starting or stopping a measurement per-
formed with the sound level meter. The trigger input is located in
at the bottom of the meter (3.5 mm headphone port).
The Date & Time menu allows you to set the time of the real-time
clock (RTC) installed in the sound level meter. Press the naviga-
tion keys <▲> and <▼> to choose the option.
By pressing the navigation keys <▲> and <▼>,
you can choose the date format or change the
date. By pressing the navigation keys <◄>
and <►>, you can choose the year, month and
day, and with the navigation keys <▲>
and <▼>, you can modify their values. Press
Follow the same procedure to change the time setting. By press-
ing the navigation keys <◄> and <►>, you can choose the hour,
minute and second, and with the navigation keys <▲> and <▼>,
you can modify their values. Press <ENTER> to save the setting.
The RTC is powered by an internal buffer battery. The RTC bat-
tery should be changed if the date and time shown on the sound
SW-BA-e-1710