Operation Guidelines; Operation; Troubleshooting - sauter SW 1000 Instruction Manual

(3) Query:
Acknowledge:
Computer
Negative acknowledge:
Computer

6. Operation guidelines

6.1 Operation

 Minimise the effect of vibration when using the sound level meter. Mechanical vi-
bration may have an adverse impact on the indications at the lower measurement
limit range, within the frequency range of the sound level meter (10 Hz to 20 kHz).
 Before the sound level meter is activated, it requires minimum 6 hours to adapt to
the environmental conditions. After adapting and activating the sound level meter,
the sound level measurement can be started immediately (no delay time is re-
quired).
 The measuring microphone is sensitive, handle it with care. Store the microphone
in the supplied box to protect it against the environment.
 Follow the instructions and operation guidelines. Prevent fall, shocks and impact
loads of the device. Operation exceeding the limits may cause damage.
 Prevent penetration of water or other liquids into the device, as it is not watertight.
 The use of high-quality alkaline batteries may extend the product service life and is
beneficial to the device. Do not use old and new batteries at the same time. Take
out the batteries if the device is not used. A battery which remains in the device for
a long time may become unsealed and cause damage to the device.

6.2 Troubleshooting

Problem
The device does not start.
Incorrect measurements.
No noticeable change of
measurement data when the
SW-BA-e-1710
instruction:
NAK
◄—
response
Query
instruction
◄—
Feedback
Query
instruction
NAK
◄—
response
Possible cause and solution
 Battery exhausted: change the battery.
 Defect of the power unit: replace the power unit.
 The ON/OFF key does not work: send the device to
the manufacturer.
Try to recalibrate the device.
 Damaged microphone: send the microphone to the
manufacturer.
►
—
Sound Level Meter
►
—
►
Sound Level Meter
43