Table of Contents
Advertisement
Chapter 4
| Interface Configuration
Trunk Configuration
5.
Configure the required settings.
6.
Click Apply.
Figure 54: Configuring LACP Parameters on a Port
To configure the connection parameters for a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step list.
3.
Select Configure from the Action list.
4.
Modify the required interface settings. (Refer to
page 95
for a description of the parameters.)
5.
Click Apply.
Figure 55: Configuring Connection Parameters for a Dynamic Trunk
To display connection parameters for a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step list.
3.
Select Show from the Action list.
– 122 –
"Configuring by Port List" on
Advertisement
Table of Contents
