Table of Contents
Advertisement
Chapter 13
| Basic Administration Protocols
Link Layer Discovery Protocol
Port Details – 802.3 Extension Trunk Information
◆
Remote Link Aggregation Capable – Shows if the remote port is not in link
aggregation state and/or it does not support link aggregation.
◆
Remote Link Aggregation Status – The current aggregation status of the link.
◆
Remote Link Port ID – This object contains the IEEE 802.3 aggregated port
identifier, aAggPortID (IEEE 802.3-2002, 30.7.2.1.1), derived from the ifNumber
of the ifIndex for the port component associated with the remote system. If the
remote port is not in link aggregation state and/or it does not support link
aggregation, this value should be zero.
Port Details – 802.3 Extension Frame Information
◆
Remote Max Frame Size – An integer value indicating the maximum
supported frame size in octets on the port component associated with the
remote system.
Port Details – LLDP-MED Capability
◆
Device Class – Any of the following categories of endpoint devices:
Class 1 – The most basic class of endpoint devices.
■
Class 2 – Endpoint devices that supports media stream capabilities.
■
Class 3 – Endpoint devices that directly supports end users of the IP
■
communication systems.
Network Connectivity Device – Devices that provide access to the IEEE 802
■
based LAN infrastructure for LLDP-MED endpoint devices. These may be
any LAN access device including LAN switch/router, IEEE 802.1 bridge, IEEE
802.3 repeater, IEEE 802.11 wireless access point, or any device that
supports the IEEE 802.1AB and MED extensions defined by this Standard
and can relay IEEE 802 frames via any method.
◆
Supported Capabilities – The supported set of capabilities that define the
primary function(s) of the port:
LLDP-MED Capabilities
■
Network Policy
■
Location Identification
■
Extended Power via MDI – PSE
■
Extended Power via MDI – PD
■
Inventory
■
◆
Current Capabilities – The set of capabilities that define the primary
function(s) of the port which are currently enabled.
7. These fields are only displayed for end-node devices advertising LLDP-MED TLVs.
7
– 374 –
Advertisement
Table of Contents
