Changing The Aging Time; Figure 95: Displaying Interfaces Assigned A Mac Address Isolation Mode - Edge-Core ECS4210-12P Web Management Manual

Chapter 6
| Address Table Settings

Changing the Aging Time

Changing the Aging Time
To show the static addresses assigned to an isolation mode:
1.
Click MAC Address, Static.
2.
Select Configure Static Address from the Step list.
3.
Select Show from the Action list.

Figure 95: Displaying Interfaces Assigned a MAC Address Isolation Mode

Use the MAC Address > Dynamic (Configure Aging) page to set the aging time for
entries in the dynamic address table. The aging time is used to age out dynamically
learned forwarding information.
Parameters
These parameters are displayed:
◆
Aging Status – Enables/disables the function.
◆
Aging Time – The time after which a learned entry is discarded. (Range: 6-7200
seconds; Default: 300 seconds)
Web Interface
To set the aging time for entries in the dynamic address table:
1.
Click MAC Address, Dynamic.
2.
Select Configure Aging from the Action list.
3.
Modify the aging status if required.
4.
Specify a new aging time.
5.
Click Apply.
– 170 –