Setting The System Clock; Setting The Time Manually - Edge-Core ECS4210-12P Web Management Manual

Setting the System Clock

Setting the Time
Manually
If a new image is found at the specified location, the following type of messages
will be displayed during bootup.
.
.
.
Automatic Upgrade is looking for a new image
New image detected: current version 1.0.1.5; new version 1.1.2.0
Image upgrade in progress
The switch will restart after upgrade succeeds
Downloading new image
Flash programming started
Flash programming completed
The switch will now restart
.
.
.
Simple Network Time Protocol (SNTP) allows the switch to set its internal clock
based on periodic updates from a time server (SNTP or NTP). Maintaining an
accurate time on the switch enables the system log to record meaningful dates and
times for event entries. You can also manually set the clock. If the clock is not set
manually or via SNTP, the switch will only record the time from the factory default
set at the last bootup.
When the SNTP client is enabled, the switch periodically sends a request for a time
update to a configured time server. You can configure up to three time server IP
addresses. The switch will attempt to poll each server in the configured sequence.
Use the System > Time (Configure General - Manually) page to set the system time
on the switch manually without using SNTP.
Parameters
The following parameters are displayed:
◆
Current Time – Shows the current time set on the switch.
◆
Hours – Sets the hour. (Range: 0-23)
◆
Minutes – Sets the minute value. (Range: 0-59)
◆
Seconds – Sets the second value. (Range: 0-59)
◆
Month – Sets the month. (Range: 1-12)
◆
Day – Sets the day of the month. (Range: 1-31)
◆
Year – Sets the year. (Range: 1970-2037)
Chapter 3
– 79 –
| Basic Management Tasks
Setting the System Clock