Table 10: Mac Address Isolation Matrix - Edge-Core ECS4210-12P Web Management Manual

Chapter 6
| Address Table Settings
Configuring MAC Address Isolation
◆
Packets are filtered or forwarded according to the isolation profiles shown in
the following table.

Table 10: MAC Address Isolation Matrix

SA Profile
Promiscuous
Promiscuous Forward
Isolated Forward
Community 1 Forward
Community 2 Forward
Parameters
These parameters are displayed:
Configure Global
◆
MAC-Isolation Global Status – Enables MAC isolation globally on the switch.
(Default: Disabled)
Configure MAC Address (Static Status - Isolation)
◆
Static Status – Sets the status to Isolation, or one of the other optional modes.
◆
MAC Isolation Mode – Sets the MAC address isolation mode to one of the
following options:
Community 1 – Forwards packets from a source address defined as
■
community 1 only to a destination address set to promiscuous mode or set
to community 1.
Community 2 – Forwards packets from a source address defined as
■
community 2 only to a destination address set to promiscuous mode or set
to community 2.
Isolated – Forwards packets from a source address defined as isolated only
■
to a destination address set to promiscuous mode.
Promiscuous – Forwards packets from a source address defined as
■
promiscuous to a destination address set to any isolation mode. Note that
promiscuous mode should be used for any uplink port that will service
downlink ports assigned to one of the other isolation modes.
For a description of the other parameters on this page, refer to
Addresses" on page 165.
Isolated
Forward
Drop
Drop
Drop
– 168 –
DA Profile
Community 1 Community 2
Forward Forward
Drop Drop
Forward Drop
Drop Forward
"Setting Static