Data Transfer Options; Transfer; Overview - Siemens SIMATIC HMI OP 73micro Operating Instructions Manual

Preparing and backing up a project

7.2 Transfer

7.1.3

Data Transfer Options

Overview

The following table shows the options for transferring data between the configuration
computer and OP 73micro or TP 177micro.
Type
Backup
Restore
Updating the operating
system
Transfer of a project
1)
2)
Serial transmission
You can use one of the following adapters for the serial transmission to the configuration PC:
● RS 232/PPI cable MM Multimaster
● USB/PPI cable MM Multimaster (as of manufacturer version 05 of the cable)
7.2 Transfer
7.2.1 Overview
Transfer
During transfer, the project is downloaded from the configuration computer to the HMI
device.
"Transfer" mode can be started on the HMI device.
Transferred data is written directly to the flash memory on the HMI device. The data channel
must be configured before you start the transfer.
92
Type
Serial (with reset to factory setting)
Serial
Serial (with reset to factory setting)
Serial
Serial (with reset to factory setting)
Serial
Serial (with reset to factory setting)
Serial
Applies to complete restore
Applies to restoring the password list
OP 73micro
No
Yes
Yes / No
1)
No / Yes
1)
Yes
No
No
Yes
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
TP 177micro
No
Yes
Yes / No
2) 1) 2)
No / Yes
2) 1) 2)
Yes
No
No
Yes