Backup And Restore Via Prosave - Siemens SIMATIC HMI OP 73micro Operating Instructions Manual

Preparing and backing up a project
7.3 Backup and restore
See also
Configure the data channel (Page 88)
Configure the data channel (Page 79)
Setting the operating mode (Page 90)
Overview of backup and restoring (Page 95)
Data Transfer Options (Page 92)
7.3.4

Backup and Restore via ProSave

Introduction
Backup and restore operations transfer the relevant data between flash memory on the HMI
device and a PC.
Requirement
● The HMI device is connected to a PC on which ProSave is installed.
● Only for restoring the password list or when backing up the data:
Procedure - backup
Proceed as follows:
1. From the Windows Start menu, run ProSave on the PC.
2. Select the HMI device type from the "General" tab.
3. Set the connection parameters in the "General" tab.
4. Use the "Backup" tab to select the relevant data.
5. Select a destination folder and a file name for the *.psb backup file.
6. Set "Transfer" mode on the HMI device.
7. Start the backup operation in ProSave with "Start Backup".
Result
The system outputs a message when the backup is completed.
The relevant data is now backed up on the PC.
98
The data channel is configured on the HMI device.
Follow the instructions in ProSave.
A status view opens to indicate the progress of the operation.
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0