6.3
Data transmission options
Overview
The following table shows the options for data transfer between the HMI device and the
configuration PC.
Action
Backup/restore,
Update operating system,
Transfer project
Update operating system with
"Reset to factory settings"
Assign IP address and device
name, edit communication
connections
6.4
Transfer
6.4.1
Overview
Transfer the executable project from the configuration PC to the HMI device.
You can start the "Transfer" mode manually or automatically on the HMI device.
Transferred data is written directly to internal flash memory of the HMI device. Assign
parameters of a corresponding data channel before you start the transfer.
6.4.2
Starting the manual transfer
Introduction
You can manually switch the HMI device to "Transfer" mode as follows:
● At runtime, using a configured operating element.
● In the Start Center of the HMI device.
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB
Data channel
MPI/PROFIBUS DP
PROFINET
USB
MPI/PROFIBUS DP
PROFINET
USB
PROFINET
Commissioning a project
6.3 Data transmission options
Basic Panels DP
Basic Panels
with PROFINET
Yes
-
Yes
-
-
Yes
-
interface
-
Yes
Yes
-
Yes
Yes
Yes
75