Mounting And Connecting The Tp 177Micro; Mounting The Hmi Device - Siemens SIMATIC HMI OP 73micro Operating Instructions Manual

Mounting and connection

4.3 Mounting and connecting the TP 177micro

4.3 Mounting and connecting the TP 177micro
4.3.1

Mounting the HMI device

Requirements
Four mounting clamps from the kit are needed to mount the the HMI device. The mounting
seal must be available on the HMI device. If the mounting seal is damaged, order a
replacement seal. The mounting seal is part of the associated service pack.
Mounting
NOTICE
Always mount the HMI device according to the instructions in this manual.
Proceed as follows:
1. Check that the mounting seal is fitted on the HMI device.
2. Insert the HMI device into the mounting cut-out from the front.
3. Insert the mounting clamps into the recesses on the side of the HMI device.
4. Tighten the clamp by screwing down the recessed head screw; permitted torque: 0.15
48
Do not install the mounting seal turned inside out. This may cause leaks in the mounting
cut-out.
Insert and then fasten all four clamps.
Figure 4-11 Installing the mounting clamp on the HMI device
Nm.
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0