Setting The Screen Saver - Siemens SIMATIC HMI OP 73micro Operating Instructions Manual

Procedure – Deleting a password
Proceed as follows:
1. Delete the entries for "Password" and "Confirm Password".
2. Close the dialog with
Result
Password protection for the Control Panel menu is revoked.
See also
Overview (Page 80)
6.2.2.6

Setting the Screen Saver

Introduction
You can set a period of time for automatic activation of the screen saver on the HMI device.
The screen saver is automatically activated if the HMI device is not operated within the
specified period of time.
The screen saver stops in the following situations:
● When you touch the touch screen.
● A message is displayed.
Requirements
The "Screen Saver" dialog has been opened with the "Screen Saver"
Figure 6-20
Procedure
Proceed as follows:
1. Enter the number of minutes before the screen saver is to be activated.
2. Close the dialog and save your entries with
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
"Screen saver" dialog
Touch the input field. You can enter a value between 5 and 360 minutes. Entering "0"
deactivates the screen saver.
6.2 Configuring the operating system for the TP 177micro
.
. Touch
Configuring the operating system
icon.
to discard the entries.
87