Siemens SIMATIC HMI OP 73micro Operating Instructions Manual page 109

Procedure – inserting characters
1. Press
2. Move the cursor to the required position.
3. Press
Example for numerical input
Activate the the input box. The following table shows the keys you need to press to enter
"–12.34":
Key
ENTER
ENTER
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
ENTER
.
INS
+ to insert a space character.
SHIFT
The characters already entered move one position to the right from the cursor position.
If the characters are right aligned:
The characters already entered move one position to the left from the cursor position.
Instruction
Press 1 x to begin input
Press 5 x to move the marking five positions to the left
DEL
Keep pressing until "-" appears
+/–
Press 1 x to move the marking one position to the right
INS
Keep pressing until "1" appears
TAB
Press 1 x to move the marking one position to the right
INS
Keep pressing until "2" appears
TAB
Press 2 x to move the marking one position to the right
INS
Keep pressing until "3" appears
TAB
Press 1 x to move the marking one position to the right
INS
Keep pressing until "4" appears
TAB
Press 1 x to end input
Operating a project
8.1 Operating a project on OP 73micro
Display
109