Siemens SIMATIC HMI OP 73micro Operating Instructions Manual page 108

Operating a project
8.1 Operating a project on OP 73micro
Procedure – editing specific characters of a value
Proceed as follows:
1. Press
2. Select the relevant character with
3. Replace the character with
4. Press
Call sequence of the characters
When you initially enter a value in an alphanumerical input field, the letter "A" is called by
pressing
The following applies for further entries:
● Press
● Press
Press
Procedure – deleting a character
1. Press
2. Position the cursor on the character to be deleted.
3. Press
108
ENTER
.
.
ENTER
This confirms your entries. To cancel the entry, press
INS
or . The same applies when you add characters.
ENTER
TAB
to enter letters.
Upper and lower case letters are indicated first, followed by the special characters and
numbers.
To toggle between an upper and a lower case letter, press
+/–
to enter numbers.
The list opens with various special characters and continues with the numbers.
+/– TAB
or to view the next value if you already entered a value.
ENTER
.
DEL
+ .
SHIFT
The selected character will be deleted. The remaining characters to the right of the cursor
shift by one position to the left.
If the characters are right aligned:
The selected character will be deleted. The remaining characters to the left of the cursor
shift one position to the right.
INS DEL
or .
TAB +/–
or .
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
.
ESC
.
SHIFT
OP 73micro, TP 177micro (WinCC flexible)