Siemens SIMATIC HMI OP 73micro Operating Instructions Manual page 83

2. The "Contrast" group contains the "UP" and "DOWN" buttons. To adjust the screen
3. The "Orientation" group contains the "Landscape" and "Portrait" buttons. To adjust the
4. The "Startup Delay" group contains the "Delay time" input field you can use to adjust the
5. Close the dialog and save your entries with
Result
You have completed your HMI device screen settings.
Screen orientation
The orientation of the screen is determined by the configuration engineer when he creates
the project. When the project is transferred to the HMI device, the appropriate screen
orientation is set automatically.
NOTICE
If there is a project on the HMI device, do not change the screen orientation.
You can change the screen orientation in the Control Panel, for example, if you have to
operate the Loader on a vertically installed HMI device without the project.
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
contrast:
– Touch the "UP" button to increase screen contrast.
– Touch the "DOWN" button to reduce screen contrast.
screen orientation:
– Set the "Landscape" check box to set the HMI device screen for horizontal orientation.
– Set the "Portrait" check box to set the HMI device screen for vertical orientation.
delay at the startup of your HMI device. The delay represents the interval in seconds
which expires between the appearance of the Loader and start of the project.
When the value "0" is set, the project starts immediately. It is then no longer possible to
call the Loader after switching on the HMI device. To handle this situation, you need to
configure an operator control object with "Close project" function.
The valid value range is 0 s to 60 s.
6.2 Configuring the operating system for the TP 177micro
. Touch
Configuring the operating system
to discard the values.
83