Mounting The Tp 177Micro; Mounting Positions And Fixation - Siemens SIMATIC HMI OP 73micro Operating Instructions Manual

3.3

Mounting the TP 177micro

3.3.1

Mounting positions and fixation

Mounting position
The HMI device is designed for mounting in racks, cabinets, control boards and consoles. In
the following, all of these mounting options are referred to by the general term "cabinet."
The HMI device is self-ventilated and approved for vertical and inclined mounting in
stationary cabinets.
Figure 3-5
①
②
③
CAUTION
Impermissible ambient temperatures
Do not operate the HMI device without auxiliary ventilation if the maximum permissible
ambient temperature is exceeded. The HMI device may otherwise get damaged and its
approvals and warranty will be void!
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
–
Permitted mounting positions
Mounting position
Inclined
Vertical
Inclined
+
Deviation from the vertical
≤ –35°
0°
≤ 35°
Planning use
3.3 Mounting the TP 177micro
33