Configuring the operating system
6.1
Configuring the operating system for the OP 73micro
6.1.1
Overview
Loader
The figure below shows the Loader. It appears briefly when the HMI device starts up.
Loader
Transfer
Start
Info/Settings
Figure 6-1
The Loader menu commands have the following functions:
● "Transfer"
● "Start"
● "Info/Settings"
The Loader also appears when you close the project.
Navigating in the Loader
Button
ENTER
HELP
ESC
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
Loader
Select this menu command to set the HMI device transfer mode.
Select this menu command to start the project which is stored on the HMI device.
Select this menu command to open the HMI device configuration menu.
+/–
TAB
or
Action
By pressing one of these buttons, you select the next menu command
in the direction of the cursor key.
The corresponding menu opens.
Returns to the next higher menu layer.
6
71