Axis StorPoint NAS 100 User Manual page 76

Appendix A: Parameter List
76
Parameter name
NTDomainInstallation
EnableNBT
NBTscopeID
EnableNetBEUI
NetBEUIFrameType
[NFS]
NFSEnable
DefaultUid
PCNFSDAuthentServer
ExportVolumes
[SNMP]
GetCommunityName
TrapDestination
TrapCommunityName
SystemContact
SystemName
SystemLocation
AuthenticationTrap
[NetWare]
NWEnable
Frame_802.2
Frame_802.3
Frame_EthernetII
Frame_SNAP
NetWareIP_Enable
NetWareIP_DSS_Server
ServerName
InternalNetAddress
BurstMode
Value
= no
= yes
=
= yes
= auto
= yes
= -2
= 0.0.0.0
= yes
= public
= 0.0.0.0
= public
=
=
=
= disabled
= yes
= auto
= auto
= auto
= auto
= no
=
= AXIS<nnnnnn>_NW
= nn-nn-nn-nn
= on
StorPoint NAS 100 User's Manual
Description
Set to yes when you want to install the StorPoint NAS in an
NT Domain.
Enables NBT over NetBIOS/TCP/IP.
Enables NetBEUI over TCP/IP.
If set to auto, 802.2 or DIX will automatically be selected by
scanning the network. If required, the frame type can also
be set to either 802_2 or dix.
Enables NFS.
Default user id to be used when authenticating PCNFSD
clients. Disable by setting the parameter to 0 (zero).
The IP address of the server used for authentication of PC
users on the UNIX (NFS) network. The default 0.0.0.0
disables the function.
Enables default export of each new disk attached. If you
restore the factory default settings, all the currently
inserted discs will be exported.
Specifies the community that has read only access to all
supported SNMP objects except writeCommunity,
SupervisorPassword and ftpPassword. It corresponds to the
readCommunity SNMP object.
Specifies the IP address which SNMP traps are sent to. It
corresponds to the trapAddress SNMP object. Default is
0.0.0.0, i.e. all SNMP traps are disabled.
Specifies the community for all generated SNMP traps. It
corresponds to the trapCommunity SNMP object.
Optional entry which should be in plain text and may be
used to show the name of the system contact person.
Optional entry which should be in plain text and may be
used to show the name of the location of the system.
Optional entry which should be in plain text and may be
used to show the name of the location of the system.
Disables the SNMP authentication failure traps. It
corresponds to the snmpenableAuthenTraps (MIB-II) SNMP
object.
Enables NetWare support.
Enables the 802.2 frame type.
Enables the 802.3 frame type (Ethernet versions only).
Enables the Ethernet II frame type (Ethernet versions only).
Enables the SNAP frame type.
Enables NetWare over the IP protocol.
The IP address of the DSS server.
NetWare server name to be presented to the NetWare
clients. Default is AXIS<nnnnnn>_NW where nnnnnn are
the last six digits of the serial number.
Internal network address. Default is nn-nn-nn-nn where
nnnnnnnn are the last eight digits of the serial number.
Burst mode enable.