Axis StorPoint NAS 100 User Manual page 19

StorPoint NAS 100 User's Manual
BOOTP
in UNIX
Follow these steps to use BOOTP in UNIX:
1. Append the following entry to your boot table (typically
/etc/bootptab
<host name>:ht=<hardware type>:vm=<vendor magic>:\
:ha=<hardware address>:ip=<IP address>:\
:sm=<subnet mask>:gw=<gateway field>
where:
for Ethernet
ht = ether
vm = rfc1048
The Ethernet or node address, i.e. the StorPoint NAS serial
ha =
number
The IP address of the StorPoint NAS
ip =
The subnet mask
sm =
The default router address
gw =
Example:
hdserv:ht=ether:vm=rfc1048:\
:ha=00408c110086:ip=192.36.253.80:\
:sm=255.255.255.0:gw=192.36.253.254
2. Make sure a unique host name is mapped to the acquired IP address.
Refer to your system manuals or to the Network Administrator for
instructions on how to perform the name mapping on your particular
system.
3. Start the BOOTP daemon (if not already running), typically by the
command:
bootpd -a
4. Restart the StorPoint NAS to download the IP address, default router
address and subnet mask.
Section 2: Basic Installation
):
19