Axis StorPoint NAS 100 User Manual page 17

StorPoint NAS 100 User's Manual
ARP in
UNIX and OS/2
Notes:
❏ If you are using host names, you can map a unique host name to the
acquired IP address. Refer to your system manuals or to the
Network Administrator for instructions on how to perform the
name mapping on your particular system.
Follow these steps to download the IP address and verify the
communication in UNIX and OS/2:
1. Type the following command:
arp -s <IP address> <Ethernet address> temp
2. Ping the unit as follows:
ping <IP address>
Example:
arp -s 192.16.253.80 00:40:8c:10:00:86 temp
ping 192.16.253.80
The host will return '
message to indicate that the address has been set and the
communication is established.
❏ Once the StorPoint NAS has established communication using an
appropriate IP address, the
the address. This is to avoid accidental or unauthorized changes.
However, if you restart the StorPoint NAS, you can change the IP
address within one hour.
❏ Please note that when you execute the
time, you may experience a significantly longer response time than
is usual.
❏ If you are using host names, you can map a unique host name to the
acquired IP address. Refer to your system manuals or to the
Network Administrator for instructions on how to perform the
name mapping on your particular system.
Section 2: Basic Installation
192.16.253.80 is alive
command cannot be used to change
arp
ping
' or some similar
,
command for the first
17