Axis StorPoint NAS 100 User Manual page 18

Section 2: Basic Installation
18
DHCP in Windows
NT and UNIX
❏ The
arp -s
BSD-type systems expect the IP address and Ethernet address in
reverse order, whereas IBM AIX systems require the additional
argument
arp -s ether <IP address> 00:40:8c:10:00:86 temp
Follow these steps to use the DHCP method:
1. Edit or create a scope in the DHCP manager of the DHCP
daemon. For Windows NT servers, refer to the "Windows NT
Resource Kit" on how to do this.
The entries made in this scope typically include the following
parameters:
• Range of IP addresses
• Subnet mask
• Default router IP address
• Lease duration
• Mail server IP address
• DNS server IP address
• WINS server IP address(es)
• Domain name
• NTP server IP address
2. Activate the scope.
DHCP is enabled by default. The IP address and all the other settings
will be downloaded automatically.
❏ To fully benefit from DHCP, it is recommended that you use the
Note:
WINS name resolution protocol available in Windows NT. If you
intend to use WINS, at least one WINS server IP address must be
included in the scope. Once the IP address is received, the
StorPoint NAS will register its host name and IP address on the
WINS server.
StorPoint NAS 100 User's Manual
command may vary from system to system. Some
. For example:
ether