Section 2: Basic Installation
20
RARP in UNIX
Follow these steps to use the RARP method in UNIX:
1. Append the following line to your Ethernet address table. This is
typically performed using the command
<Ethernet address> <IP address>
Example:
00:40:8c:10:00:86 192.16.253.80
2. If you are using host names, you can map a unique host name to the
acquired IP address. Refer to your system manuals or to the Network
Administrator for instructions on how to perform the name mapping
on your particular system.
3. If it is not already running, start the RARP daemon. This is typically
done using the command
4. Restart the StorPoint NAS to download the IP address.
StorPoint NAS 100 User's Manual
/etc/ethers
rarpd -a.
: