Alcatel-Lucent 7210 SAS-D Configuration Manual page 80

Monitor CLI Commands
-------------------------------------------------------------------------------
Ingress Meter 1 (Unicast)
For. InProf : 0
For. OutProf :
Ingress Meter 11 (Multipoint)
For. InProf :
For. OutProf :
===============================================================================
A:7210SAS-E>monitor>service>id#
sdp
Syntax sdp {sdp-id | far-end ip-address} [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>service>id service-id
Description
This command monitors statistics for a SDP binding associated with this service.
Parameters sdp-id — Specify the SDP identifier.
absolute — When the absolute keyword is specified, the absolute rate-per-second value for each
far-end ip-address — The system address of the far-end 7210 SAS for the SDP in dotted decimal
interval seconds — Configures the interval for each display in seconds.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
repeat repeat — Configures how many times the command is repeated.
Sample Output
A:ALA-12# monitor service id 100 sdp 10 repeat 3
===============================================================================
Monitor statistics for Service 100 SDP binding 10
===============================================================================
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
-------------------------------------------------------------------------------
At time t = 11 sec (Mode: Delta)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
Page 80
Packets Octets
0
210645 0
0 0
87238 0
Values 1 — 17407
statistic is displayed.
notation.
Default 11 seconds
Values 11 — 60
of the delta.
Default
10
Values 1 — 999
7210 SAS D, E, K OS Basic System Configuration Guide