Modifying And Saving A Configuration - Alcatel-Lucent 7210 SAS-D Configuration Manual

Service Management Tasks

Modifying and Saving a Configuration

If you modify a configuration file, the changes remain in effect only during the current power
cycle unless a
router is rebooted without saving.
•
•
•
•
The following command saves a configuration:
CLI Syntax: bof# save [cflash-id]
Example
The following command saves the system configuration:
CLI Syntax: admin# save [file-url] [detail] [index]
Example
NOTE: If the
with an FTP path used as the
FTP server. The FTP server must be configured to allow multiple sessions from the same login,
otherwise, the configuration and index files will not be saved correctly.
Page 148
command is executed. Changes are lost if the system is powered down or the
save
Specify the file URL location to save the running configuration. If a destination is not
specified, the files are saved to the location where the files were found for that boot
sequence. The same configuration can be saved with different file names to the same
location or to different locations.
The detail option adds the default parameters to the saved configuration.
The index option forces a save of the index file.
Changing the active and standby addresses without reboot standby CPM may cause a
boot-env sync to fail.
: A:
ALA-1# bof
A:
ALA-1>bof# save cf1:
A:
ALA-1>bof#
: A:
ALA-1# admin save cf1:\test123.cfg
Saving config.# Saved to cf1:\test123.cfg
... complete
A:
ALA-1#
option is enabled and the
persist
file-url
7210 SAS D, E, K OS Basic System Configuration Guide
admin save file-url
parameter, two FTP sessions simultaneously open to the
command is executed