Table 16: Show Bof Output Fields (Supported Only On 7210 Sas-E) - Alcatel-Lucent 7210 SAS-D Configuration Manual

Show Commands
Table 15: Show BOF Output Fields (Continued)
.

Table 16: Show BOF Output Fields (supported only on 7210 SAS-E)

Sample Output
*A:ALA# show bof cf1:
===============================================================================
BOF on cf1:
===============================================================================
Page 174
Label
autonegotiate
console speed
ping-address
dns domain
uplinkA-address
uplinkA-port
uplinkA-route
uplinkA-vlan
uplinkB-address
uplinkB-port
uplinkB-route
uplinkB-vlan
console-disabled
Label
eth-mgmt-disabled
eth-mgmt-addressg
eth-mgmt-route
eth-mgmt-autoneg
eth-mgmt-duplex
eth-mgmt-speed
7210 SAS D, E, K OS Basic System Configuration Guide
No autonegotiate — Autonegotiate not enabled.
autonegotiate — Autonegotiate is enabled.
The console port baud rate.
The IPv4 IP address to be used for ping-test after auto-init.
The domain name used when performing DNS address resolution.
Displays the Uplink-A IP address.
Displays the primary port to be used for auto-boot.
Displays the static route associated with Uplink-A.
Displays the VLAN ID to be used on Uplink-A.
Displays the Uplink-B IP address.
Displays the secondary port to be used for auto-boot.
Displays the static route associated with Uplink-B.
Displays the VLAN ID to be used on Uplink-B.
Displays the status of serial port console.
Displays if Ethernet management is disabled.
Displays the Ethernet management address.
Displays the Ethernet Management route.
Displays if the auto-negotiate is enabled.
Displays the mode of the Ethernet management port.
Displays the Ethernet management speed.
Description
Description